A Homemade Sawdust-Control System for the Home Woodshop

1 / 7
Saw table and dust hose cutting list.
Saw table and dust hose cutting list.
2 / 7
Bill and his innovative saw table. We modified his design a bit to allow the dust hose to connect to the table bottom.
Bill and his innovative saw table. We modified his design a bit to allow the dust hose to connect to the table bottom.
3 / 7
Diagram: Saw table and dust hose.
Diagram: Saw table and dust hose.
4 / 7
Diagram: Parts of saw table and dust hose 2.
Diagram: Parts of saw table and dust hose 2.
5 / 7
Diagram: Parts of saw table and dust hose 1.
Diagram: Parts of saw table and dust hose 1.
6 / 7
Diagram: Parts of saw table and dust hose 3.
Diagram: Parts of saw table and dust hose 3.
7 / 7
Diagram: Parts of saw table and dust hose 4.
Diagram: Parts of saw table and dust hose 4.

Learn how to build this low-cost homemade sawdust-control system and saw table. 

If you’ve ever been inside a state-of-the-art woodworking shop, you’ve probably noticed an unusual lack of airborne sawdust. That’s because the large shops spend thousands of dollars on elaborate ventilation systems that remove sawdust from the indoor environment. With clean air filtered in and fine dust particles filtered out, these systems allow workers to breathe easier knowing that there’s one less on-the-job health risk. For those of us who work at home or in the garage, it just hasn’t been practical to install our own ventilation system . . . until now. 

While it may not be economically feasible to install a sawdust-control system for the entire garage, we can assemble a self-contained homemade sawdust-control system for one of the greatest contributors of sawdust in the shop: the table saw. And while prices will vary at lumberyards around the country, $60 should be enough for the wood, hardware, glue and paint needed for this project, give or take a few bucks. Throw in a five-gallon, 1.5-horsepower Shop Vac® for around $40, and a dust-free garage is easily worth the price.

Our table saw is located in an end-of-the-garage workshop where space is very limited (it’s no more than 5 feet by 12 feet). After acquiring a basic no-frills table saw, I decided I needed a saw table that would meet several requirements. First, it had to be comfortable for my 6 foot 4 inch height. I also wanted it to be easy to move and fairly easy to dismantle for convenient storage. Most importantly, however, the table had to have a built-in sawdust evacuation system because the people in my household are allergic to sawdust. In the end I was unable to find a commercially made saw table that met all of these requirements, so I decided to build my own.

The Table Top and Base

  • Published on Oct 1, 2000
Online Store Logo
Need Help? Call 1-800-234-3368